Phone:  661 324-5450    Fax:  661 324-5451    E-mail:  don@inspect2020.net
Request an Inspection

There are routine safety and maintenance steps that you should follow once a month. Review your owner's manual for the door opener. If you don't have the owner's manual, look for the opener model number on the back of the power unit and request a manual from the manufacturer.

Reversal Test
Make sure your opener has a reversing feature. If a reversing feature is not present, it should be replaced. Garage door openers manufactured after January 1, 1993 are required by federal law to have advanced safety features which comply with the latest U.L. 325 standards: Contact your manufacturer or installer for additional information.

Test the reversing feature every month.

• First, test the balance of the door. If the door is properly balanced, then proceed.
• With the door fully open, place a 1-1/2" thick piece of wood (a 2" x 4' laid flat) on the floor in the center of the door.
• Push the transmitter or wall button to close the door. The door must reverse when it strikes the wood. (Note that the bottom part of "one piece doors" must be rigid so that the door will not close without reversing.)
• If the door does not reverse, have it repaired or replaced. Have a qualified individual adjust, repair or replace the opener or door.

Back to Newsletters